Toa N-8000 Series - Manual (Page 260)

2-149
Chapter 2 FUNCTIONS AND OPERATION
N-8000AL TELEPHONE INTERFACE CONNECTED TELEPHONE
[Operation]
Step 1. Automatic Scan
1-1. When scan-monitoring the preprogrammed stations:
Press the [ ] and [2] keys, then monitor group number (1 − 4), followed by the [#] key.
When monitoring two or more groups, dial the group numbers consecutively.
1-2. When scan-monitoring by designating the station numbers:
Press the [ ], [2], [ ] keys, then the station number.
To select the station number consecutively, press the [ ] key.
To terminate the station selection, press the [#] key following the station number.
Scan monitoring is started and cycles through the station groups in preprogrammed sequence and at
specified time intervals until its operation is manually stopped.
Step 2. Manual Scan
2-1. Stopping and restarting automatic scan
To continuously monitor a specified station, press the [0] key when that station is displayed to stop
automatic scan operation. Pressing the [0] key again restores automatic scan operation.
2-2. Advancing a scan
Pressing the [#] key advances the scan by one station.
2-3. Moving back a scan
Pressing the [ ] key moves the scan back one station.
Step 3. Scan Monitor end
To end Scan monitor, replace the handset.