Toa N-8000 Series - Manual (Page 170)

2-59
Chapter 2 FUNCTIONS AND OPERATION
MASTER STATION'S FUNCTIONS AND OPERATION
5.5.3. Receiving calls from an outside line telephone
There are two modes for receiving calls from an outside line telephone: Direct-In Line and Direct-In Dialing. The
audible call tone for a received outside line call is different from those of other incoming calls. (Refer to "List of
Signal Tones" on p. 2-193 .)
[Calls by Direct-In Line]
When a call is received from an outside line telephone, a call tone is sounded at the preprogrammed Master
Station and its member stations. One (1) Master Station can also be designated as a representative station and
up to three other Master Stations as member stations for each N-8000CO.
Notes
• Settings must be made so that Direct-In Line calls can be received.
• Use the supplied N-8000 Setting Software to enable or disable Direct-In Line call reception. (Refer to p.
5-90 .)
• Use the supplied N-8000 Setting Software to set a representative station and its member stations to receive
Direct-In Line calls. (Refer to p. 5-90 .)
When the call tone sounds, answer the call. (For the operating procedure, refer to p. 2-3 .)
Call tones at all master stations stop, allowing the master station that answered to initiate the
conversation.
Call tone
or
X
[Calls by Direct-In Dialing]
Stations can be called individually from an outside line telephone by dialing the station number. N-8000 system
stations can receive Direct-In Dialing calls from an outside line telephone in the same way as receiving calls
from a system station.
Notes
• Calls are automatically terminated if the caller pauses for more than five seconds while dialing the number.
• Call mode is automatically switched to Direct-In Line if the caller does not dial the station number within 10
seconds after hearing a Direct-In Dialing confirmation tone.
• Settings must be made to enable Direct-In Dialing.
• Use the supplied N-8000 Setting Software to enable or disable Direct-In Dialing.