Toa N-8000 Series User Manual

Page 160

2-49

Chapter 2

FUNCTIONS AND OPERATION

MASTER STATION'S FUNCTIONS AND OPERATION

Step 3. The conference is terminated when the originator of the conference either presses the Clear key or

replaces the handset.

This completes the conference call.

Tip

If a called party other than the originator of the conference

presses the Clear key or replaces the station handset, that

party can exit the conference. (The originator represents

the station that called the third party.)

Note

For operation details, refer to the next item "Operation details of 3-party conference."

5.2.3. Operation details of 3-party conference

(1) If the station unable to participate in the conference (Door station, substation, Master station connected to

the N-8010EX/8400RS, N-8610RM IP Remote Microphone Station, outside line telephone connected to

the N-8000CO, or telephone connected to the N-8000AL) is dialed, an error tone sounds at the originating

station, reverting to the original conversation between the two.

(2) If the called Master Station responds in hands-free mode, the calling party's voice can be heard from the

called station's speaker (hands-free voice reception mode). Lift the handset to talk.

(3) If the called master station is set for Call forwarding, conference call is automatically transferred only to the

transfer destination master station. Conference call is not transferred to the destination station other than

the destination master station.

(4) When the called third party is busy, a busy tone is transmitted to the calling party and the calling party must

wait. As soon as the third party finishes its conversation, the calling party is automatically put through to the

third party. (Camp-On Busy mode)

(5) If the Call Back function is performed*

while attempting to call the third party, the call is canceled, and the

original conversation is restored*

(6) If the originator of the conference presses the Transfer key followed by the participant station number during

3-party conference, the designated station is cancelled, reverting to the original conversation between the

two.

Press the Transfer key.

Pressing the Clear key or replacing the handset while attempting to call the third party will terminate the

conference.