Toa N-8000 Series - Manual (Page 251)

2-140
Chapter 2 FUNCTIONS AND OPERATION
N-8000AL TELEPHONE INTERFACE CONNECTED TELEPHONE
6 2 No. 61
No. 62
(The originally called
station, which has been
set to the Call forwarding mode)
No. 63
(The designated transfer destination station)
Call tone
2.3.3. Call forwarding
Calls to telephones set for Call forwarding are automatically transferred to another designated station or
telephone without sounding a call tone.
Two different modes are available: one is Call forwarding, in which calls are manually rerouted to the selected
station, and the other is Time-based Call forwarding, which transfers calls only when the preset time is reached.
This Call forwarding function also applies to the call transfer ( p. 2-15 ) performed during conversations.
The telephone to which a Call forwarding is to be transferred can be set either by dialing operation (see below
and p. 2-141 ) or using the supplied N-8000 Setting Software. (Refer to p. 5-99 .)
Use the supplied N-8000 Setting Software to enable or disable the Call forwarding function or to set the transfer
start/end time. (Refer to p. 5-97 .)
The telephone to which a call is to be transferred cannot be designated unless the Call forwarding function is
enabled.
Note
Calls are not transferred if the telephone set for Call forwarding is called as an associated member station of
the group.
[Calls to stations manually set for Call forwarding]
Calls to the telephone manually set for Call
forwarding are automatically transferred to
the designated station without sounding a
call tone.
Programming can be performed at your telephone (Call forwarding telephone) or the transfer destination
station, while erasure at your telephone.
[Programming at your telephone]
+ + + (Confirmation tone)
Function designation
number
Transfer destination
station number
+ + + (Confirmation tone)
The originally called (your)
telephone number
+ + + (Confirmation tone)
The originally called (your)
telephone number
Function designation
number
Function designation
number
4 1 X X
4 2 Y Y
4 1 Y Y
[Erasure]
(available only at your telephone)
[Programming at the transfer
destination station]
Notes
• The telephone to which a call is to be transferred via multi interface unit or C/O line interface unit cannot
be programmed as a transfer destination station.
• The programmed contents by dialing operation are automatically saved into the C/O line interface unit at
midnight every day. If the C/O line interface unit is turned off before completion of save, the state returns
to the contents that were programmed before power-off.