Toa N-8000 Series - Manual (Page 275)

2-164
Chapter 2 FUNCTIONS AND OPERATION
OPERATION FROM AN OUTSIDE LINE
2.3. All-Call Paging
Paging calls can be made simultaneously to all of the pre-programmed zones.
Use the supplied N-8000 Setting Software to set the paging zones. (Refer to p. 5-121 .)
Step 1. Lift the handset and dial the N-8000CO's outside line number.
The N-8000CO unit automatically responds to the call and a dial confirmation tone is transmitted to
the caller.
Step 2. After hearing the confirmation tone, press the [ ][8] keys, followed by the paging zone number 0 (for
all-call paging).
A paging tone is transmitted to all zones.
Note
Enter a zone number with the digit length (1 − 3 digits) set with the N-8000 Setting Software.
Step 3. Page with the handset.
Note
If the system's paging response mode has been set for Zone number designation response (refer to p.
2-32 ), notify the paged party to respond to [0] in the paging message.
Step 4. Either replace the handset or press the [0][0][#] keys.
The paging is completed.
Notes
• A repeated busy tone is heard at paged stations if the handset is replaced to terminate paging.
• If paging is terminated by [0][0][#] key operation, the DTMF signal tones of these keys are heard at
paged stations.
Zone 1
Amplifier
Speakers
No. 100
Zone 192
Amplifier
Speaker
1, 2
4
3
0 0 0
8
X X
0 0
or
(Zone number with 3-digit length)
(Dial confirmation tone)
N-8000CO's outside line number