Toa N-8000 Series - Manual (Page 228)

2-117
Chapter 2 FUNCTIONS AND OPERATION
DOOR STATION'S FUNCTIONS AND OPERATION
DOOR STATION'S
FUNCTIONS AND OPERATION
The call tone is heard through the calling station's internal speaker.
• If the door station is not set to door station mode, a busy tone is heard when
the called master station is busy. When a busy tone is heard, wait till the
line becomes free, and you are automatically connected to the called party.
[When the door station is set to door station mode]
The call tone sounds only once regardless of the called station's connection
mode settings.
When no response is made to a call within 30 seconds, the call automatically
stops, as the call timeout is limited to 30 seconds in this mode.
[When the door station is not set to door station mode]
When the called master station is set to Automatic connection mode, it is
possible to start conversations after a brief call tone is sounded once.
When the called master station is set to Continuous call tone mode, the call
tone continues to sound and stops when the called party answers, allowing
conversations to start.
Note
Calls cannot be terminated at the door station.
Step 2. Start conversation when the called party answers.
[When the door station is set to door station mode]
Conversation automatically terminates in 30 seconds, as the conversation
timeout is limited to 30 seconds.
Tip
This 30-second limit becomes invalid when lifting the handset, or pressing the hold key or transfer key
at the master station.
[When the door station is not set to door station mode]
Conversation mode continues until the called party replaces the handset of
the master station or telephone, or presses the Clear key.
Note
Conversation cannot be terminated at the door station.
Notes
• Preprogram the master station or the telephone to call to.
Programming can be performed by dialing operation of the multifunctional master station (refer to p. 7-9 ) or
using the supplied N-8000 Setting Software (refer to p. 5-68 , 5-83 ).
• Use the supplied N-8000 Setting Software to perform Door station mode setting. (Refer to p. 5-67 , 5-82 .)
1. CALLING FROM A DOOR STATION
1.1. Calling from a Door Station
(when the system is set to "Sequential Response" mode)
Step 1. Press the call button to call the pre-programmed master station or telephone.
Call tone