Toa N-8000 Series - Manual (Page 277)

2-166
Chapter 2 FUNCTIONS AND OPERATION
OPERATION FROM AN OUTSIDE LINE
or
0 0
[Operation]
Step 1. Lift the handset and dial the N-8000CO's outside line number.
The N-8000CO unit automatically responds to the call and a dial confirmation tone is transmitted to
the caller.
Step 2. Automatic Scan
2-1. When scan-monitoring the preprogrammed stations:
After hearing the dial confirmation tone, press the [ ][2][Outside Line Control Password* (4 digits)]
[Monitor Group No. (1 − 4)][#] keys in sequence.
* The outside line control password is required only when it has been set.
Note: When monitoring two or more groups, press the group numbers consecutively.
2-2. When scan-monitoring by designating the station numbers:
After hearing the dial confirmation tone, press the [ ][2][Outside Line Control Password* (4 digits)]
[ ][Station No.] keys in sequence.
To select the station numbers consecutively, press the [ ] key.
To terminate the station selection, press the [#] key.
* The outside line control password is required only when it has been set.
• Scan monitoring starts and cycles through the station groups in preprogrammed sequence or in order
of being selected at specified time intervals until its operation is manually stopped (Step 3).
• When the station to be monitored is switched to another, a monitor start tone (key touch tone) is heard
at the outside line telephone.
• When the station to be monitored is busy, a 1-sec. busy tone is transmitted to the outside line
telephone.
Step 3. Either replace the handset or press the [0][0][#] keys.
The scan monitor ends.
during monitoring.
Note
In the case of the RS-140/180/480, the status indicator does not light even if set to "Display ON" mode.