To perform an auto transition, Transitions using e-mem, E-mem operations – Grass Valley Zodiak v.6.0 Mar 15 2006 User Manual
Page 379: Recalling registers, To recall a register in the same bank, To recall a register from a different bank
Zodiak — User Manual
379
E-MEM Operations
To Perform an Auto Transition
Setup:
1.
Setup for an Auto Transition is the same as a lever arm transition (see
) with the following added step:
2.
Specify the duration of the transition by turning on the
Trans Rate
button, selecting the flashing button of the desired element, and
entering a value in
Entry
). Different durations can be specified by repeating
this process for each element.
Perform:
3.
Press the
Auto Trans
button. The picture will transition only the elements
selected at the specified rate(s). Other elements will remain unchanged.
Transitions Using E-MEM
Transitions can also be built into E-MEMs. See E-MEM Transitions
E-MEM Operations
Recalling Registers
The Zodiak system is optimized for rapid effects recall, generally accom-
plished with a single keystroke. To access a different bank, two keystrokes
may be required.
Note
If recalling effects from the Master E-MEM subpanel with Auto Recall off,
you first need to specify which levels you wish to control with the Enable but-
tons.
To Recall A Register in the Same Bank
1.
Press the E-MEM subpanel keypad number of the desired register.
To Recall A Register from a Different Bank
1.
Press the ↑
↑
↑
↑
Bank
button, then press the keypad number of the desired
bank.