Grass Valley Zodiak v.6.0 Mar 15 2006 - Manual (Page 239)

Zodiak — User Manual 239
Timeline Menus
Keyframe Edit subpanel or the soft button in the Timeline – Edit menu can
be used to return work buffer and source memory settings to known states.
This can be helpful when creating effects.
Work buffer and source memory values are not set to zero when they are
cleared. Instead, previously defined settings replace the current settings.
The Default Keyframe is a single group of settings defining a particular
switcher state. These settings are copied to the work buffer when the work
buffer is cleared (see Default Keyframe
on page 76 ). The Default Source
Memory defines settings for each source. These settings are used when the
source memory is cleared (see Effect Register, Work Buffer, and Current Effect
on page 66 ).
When source memory is on, the following actions can be performed with
the
Clear Wk Bfr button.
• Pressing Clear Wk Bfr once clears all the work buffers parameters except
those associated with source memory in all levels enabled in the Master
E-MEM subpanel.
• Pressing Clear Wk Bfr twice rapidly clears all the work buffer parameters
for all the enabled levels, and also clears the source memories of the
sources currently selected in the enabled levels.
• Pressing Clear Wk Bfr once while holding down at least one source select
button, clears only the source memory related parameters for each held
down source. The Master E-MEM enables have no bearing on this oper-
ation.
• Pressing Clear Wk Bfr twice rapidly while holding down at least one
source select button, clears the source memory related parameters and
all the work buffer parameters for the level of the source button held
down. This includes source selections on the key buses and the associ-
ated keyers. The Master E-MEM enables have no bearing on this oper-
ation.
When source memory is off, the separate source memory area and the
Source Memory Default values are not used. In this situation, source
memory related parameters cleared with the
Clear WkBfr button will be
replaced with Default Keyframe parameters.
Restore Work Buffer Button
Rest WrkBfr – This is a soft button in the Timeline Edit menu. Touching this
button restores the work buffer to its original keyframe values or interpo-
lated state. For example, if you recall an effect and make changes to its set-
tings in the work buffer, pressing
Rest WrkBfr removes the changes that were
made and restores the original values. Rest WrkBfr is useful if during effect
editing you accidentally change the wrong parameter.