Delta DVP-ES2 - Manual (Page 93)

2 . P r o g r a m m i n g C o n c e p ts
DABSR:
1. M1029= ON when instruction is completed.
2. When the instruction is re-executed for the next time, M1029 will turn off first then ON again
when the instruction is completed
ZRN, DRVI, DRVA:
1. M1029 will be “ON” after Y0 and Y1 pulse output is completed. M1102 will be “ON” after Y2
and Y3 pulse output is compeleted.
2. When the instruction is re-executed for the next time, M1029 / M1102 will turn off first then
ON again when the instruction is completed.
Clear Instruction Function Group
M1031, M1032 Number
Contents:
M1031 (clear non-latched memory) , M1032 (clear latched memory)
Device Devices will be cleared
M1031
Contact status of Y, general-purpose M and general-purpose S
ƒ General-purpose contact and timing coil of T
Clear non-latched area
ƒ General-purpose contact, counting coil reset coil of C
ƒ General-purpose present value register of D
ƒ General-purpose present value register of T
ƒ General-purpose present value register of C
M1032
Contact status of M and S for latched
Clear latched area ƒ Contact and timing coil of accumulative timer T
ƒ Contact and timing coil of high-speed counter C for latched
ƒ Present value register of D for latched
ƒ Present value register of accumulative timer T
ƒ Present value register of high-speed counter C for latched
Output State Latched in STOP mode Function Group
M1033 Number
Contents:
When M1033 = ON, PLC outputs will be latched when PLC is switched from RUN to STOP.
Disabling all Y outputs Function Group
M1034 Number
Contents:
When M1034 = ON, all outputs will turn off.
2 - 6 1