Delta DVP-ES2 - Manual (Page 685)

7 C AN o p e n F u n c t i o n a n d O p e r a t i o n
7 - 2 9
Item Explanation Default
COM port
The serial port of computer used for communication
with DVP-ES2-C.
COM1
Address The communication address of DVP-ES2-C 01
Baud rate
The communication rate between computer and
DVP-ES2-C
9600 bps
Data bits
7
Parity
Even parity
Stop bit
The communication protocol between computer and
DVP-ES2-C
1
Mode
The communication mode between computer and
DVP-ES2-C
ASCII Mode
3) After setting is finished, click “Network”> “Online” and the “Select communication channel”
page appears.
1> When “CANopen Slave” displays in the Name column, it indicates that PLC is in the
mode of CANopen slave. At that time, select “Simulated online” on the bottom left side
on the page and finally click “OK” to start the online scanning.
2> When “CANopen Master” displays in the Name column, it indicates that PLC is in the
mode of CANopen master. At that time, directly click “OK” to start the online scanning.