Delta DVP-ES2 - Manual (Page 596)

D V P - E S 2 / S X 2 / S S 2 / S A2 / S X 2 / S E O p e r a t i o n M a n u a l – P r o g r a m m i n g
3 - 4 8 0
API Mnemonic Operands Function
272 D BANI
Connect NC Contact in Series by
Specified Bit
Controllers
ES2/EX2 SS2 SA2
SE
SX2
Bit Devices Word devices Program Steps Type
OP X Y M S K H KnX KnY KnM KnS T C D E F
S * * * * * *
n * * * * * * * * * * *
BANI: 5 steps
DBANI: 9 steps
PULSE 16-bit 32-bit
ES2/EX2 SS2
SA2
SE
SX2 ES2/EX2 SS2
SA2
SE
SX2 ES2/EX2 SS2
SA2
SE
SX2
Operands:
S: Reference source device n: Reference bit
Explanations:
1. For ES2/EX2 models, only V1.20 or above supports the function
2. Available range for the value in operand n: K0~K15 for 16-bit instruction; K0~K31 for 32-bit
instruction.
3. BANI instruction is used to connect NC contact in series, whose state is defined by the
reference bit n in reference device D, i.e. if the bit specified by n is ON, the NC contact will be
ON, and vice versa.
Program Example:
X1
BANI D0 K0 Y0
Instruction: Operation:
LDI X1 Load NC contact X1
BANI D0 K0 Connect NC contact in series
, whose state is defined by
bit0 of D0
OUT Y0 Drive coil Y0