Delta DVP-ES2 - Manual (Page 266)

D V P - E S 2 / E X 2 / S S 2 / S A2 / S X 2 / S E O p e r a t i o n M a n u a l - P r o g r a m m i n g
3 - 1 5 0
output will stop after 1,000,000 pulses are completed.
„ When pulse output ramps down and stops after Mark is detected, M1538 will be ON to
indicate the pause status. If users need to complete the remaining pulses, set OFF the
flag M1108 and pulse output will resume.
74. Operation of Mask function on Y0:
Frequency
Start/end
frequency
Target
speed
Y0 is masked from
interrupts on X4 Y0 is ready for
interrupts from X4
Pulse number if no
external interrupt on X 4
Time
D1340
Pulses to be m asked,
Ramp down time
(D1348)
Specified by DD1026
Ramp-down stop pulse
number when M ark
is detected (D
) D1232
Pulse
number
„ Mask function on Y0 will be enabled when D1026 and D1027 are specified with values other
than 0. Mask function is disabled when D1026 and D1027 are specified with 0. If pulse output
process can not reach the target speed, PLC will clear DD1026 to disable the Mask function. If
the Mask range is set to be within the ramp-up section, PLC will automatically modify DD1026
to be longer than the ramp-up section. On the other hand, if DD1026 is set between ramp-
down section, PLC will modify DD1026 to be the range before the beginning of ramp-down
process. Mask function setting method on Y2 is the same as Y0.
Program example 2:
M0
Y0
M0
M1000
I401
SET M1156
DMOV
DPLSR K100000 K1000000 K20
FEND
INCP D0
IRET
END
DMOV K10000 D1232
K50000 D1026