Delta DVP-ES2 - Manual (Page 158)

D V P - E S 2 / S A 2 / S S 2 / S A2 / S X 2 / S E O p e r a t i o n M a n u a l - P r o g r a m m i n g
3 - 4 2
3.8 Detailed Instruction Explanation
API Mnemonic Operands Function
00 CJ P Conditional Jump
Controllers
ES2/EX2 SS2
SA2
SE
SX2
OP Range Program Steps
P0~P255 CJ, CJP: 3 steps
PULSE 16-bit 32-bit
ES2/EX2 SS2
SA2
SE
SX2 ES2/EX2 SS2
SA2
SE
SX2 ES2/EX2 SS2
SA2
SE
SX2
Operands:
S: The destination pointer P of the conditional jump.
Explanations:
1. If users need to skip a particular part of PLC program in order to shorten the scan time and
execute dual outputs, CJ instruction or CJP instruction can be adopted.
2. When the program designated by pointer P is prior to CJ instruction, WDT timeout will occur
and PLC will stop running. Please use it carefully.
3. CJ instruction can designate the same pointer P repeatedly. However, CJ and CALL cannot
designate the same pointer P; otherwise operation error will occur
4. Actions of all devices while conditional jump is being executed:
a) Y, M and S remain their previous status before the conditional jump takes place.
b) 10ms and 100ms timer that is executing stops.
c) Timer T192 ~ T199 that execute the subroutine program will continue and the output contact
executes normally.
d) The high-speed counter that is executing the counting continues counting and the output
contact executes normally.
e) General counters stop executing.
f) If timer is reset before CJ instruction executes, the timer will still be in the reset status while
CJ instruction is being executed.
g) The application instructions that are being executed, i.e. DHSCS, DHSCR, DHSZ, SPD,
PLSY, PWM, PLSR, PLSV, DRVI, DRVA, continue being executed.