Echelon SmartServer 2.2 - Manual (Page 81)

82 Configuring and Managing the SmartServer
5. The Setup – Web Service Web page opens.
6. Configure the following properties for the Web Connection Target server:
SmartServer
Property
SOAP Path Enter the path on the Web Connection Target server to which SOAP
messages should be transmitted. This is typically
/LnsProxy/LnsProxyService (the location of the SOAP path to the
Echelon Enterprise Service running on your computer) .
HTTP Port (Web
Server/SOAP) Enter the port that the Web Connection Target server uses to serve HTTP
requests (SOAP and WebDAV). The default value is 80, but you may
change it to any valid port number. Contact your IS department to ensure
your firewall is configured to allow access to the server on this port.
Select SSL to create a secure Web connection. Enter the port number to
use for the SOAP interface. The default port used for SSL is 443, but you
may change it to any valid port number.
SOAP User Name Optionally, you can enter a user name to be used for logging in to the Web
Connection Target server.
SOAP Password If you create a Web Connection Target server, click Change Password to
enter the password to be used for logging in to the Web Connection Target
server.
Retry Time Set the amount of time (in seconds) after which the Web Connection
Target server will stop attempting to resend failed Web Connection
connection messages. The default value is 120 seconds.
The Web Connection Target server automatically attempts to resend failed
Web Connection connection messages every 45 seconds.
Format Values in
Web Connection
SOAP Messages
Using Select how data point values are formatted in SOAP messages sent to this
Web Connection Target server via Web connections. You have two
choices:

Data Point Format. Data point values are formatted based on the
SNVT, UNVT, SCPT, or UCPT defined for the data point.