Echelon SmartServer 2.2 - Manual (Page 103)

104 Configuring and Managing the SmartServer
3. The following system information related to your SmartServer’s hardware and firmware and its
Ethernet connections are displayed in the dialog:
SmartServer This section displays information about the SmartServer hardware and
firmware. This information may be requested by Echelon support when
diagnosing a problem with the SmartServer.
Model Number The SmartServer’s model number.
Channel Type The channel type of the SmartServer. For free topology models of the
SmartServer, this is TP_FT_10. For power line models, this is PL_20N
(or PL-20C if CENELEC is enabled).
Modem Installed Indicates whether the SmartServer has an internal modem.
CPU Speed The CPU speed (in MHz) of the SmartServer.
Firmware Version The firmware version of the SmartServer.
Bootrom Version The bootrom version of the SmartServer.
Hardware
Revision The hardware version of the SmartServer, which is one of following
values:
1 - Release 1 hardware
2 - e3 hardware
3 - SmartServer hardware
Ethernet This section lists the Ethernet addresses currently used by the
SmartServer.
MAC Address The unique 12-digit hexadecimal Ethernet MAC address assigned to the
SmartServer. A MAC address consists of a Block ID and a Device ID.
The Block ID (the first set of six digits) identifies the manufacturer. The
Device ID (the second set of six digits) identifies the model and
manufacturer date.
LAN IPv4 Address The IPv4 address currently assigned to the SmartServer.
LAN IPv6 Address The IPv6 address currently assigned to the SmartServer. This field will be
empty if IPv6 is not enabled on your SmartServer.
GPRS Network IP
Address The IP address used by the SmartServer for GPRS network connections.
If a GPRS connection has not been set up on your SmartServer,
“Not Connected” appears in this field.
4. You can scroll down to view the following properties related to the SmartServer’s general
performance: