Echelon SmartServer 2.2 - Manual (Page 512)

SmartServer 2.2 User’s Guide 513
Command Description
dump ip852config Copies the IP-852 configuration to the
//ltconfig/xmldump/LTIP_config.xml file.
enable service Enables a service. Available services are:

Ftp – FTP access.

Web – HTTP access.

Dial-in – Dial-in access.

ipv4DnsServerViaDhcp – Obtaining DNS Server from DHCP
when using IPv4.

ipv4DnsDomainViaDhcp – Obtaining DNS suffix via DHCP
when using IPv4.

ipv6dhcp dnsdomain – Obtaining DNS suffix via DHCP when
using IPv6.

ipv6dhcp dnsserver – Obtaining DNS Server from DHCP when
using IPv6.

ipv6ManualAddress – Manually setting the IPv6 network
address and gateway address with the IPv6address,
IPv6prefixlength and IPv6gateway commands.

ipv6stack – Enables the IPv6 interface on the SmartServer.

SecureAccess – Enables security access mode temporarily, until
the next time the SmartServer is rebooted. You can also disable
security access mode with the disable command after running this
command.

SecureAccess always – Enables security access mode persistently.
This is the default setting. You can disable security access mode
with the disable command.
ethernetspeed mode Sets the Ethernet speed (10 or 100 MB per second) and mode
(full-duplex or half-duplex) of the SmartServer to one of the following
values:

auto (auto-negotiation). The SmartServer employs auto
negotiation to determine the Ethernet speed and mode to use based
upon the device with which it is communicating. This is the
default.

100f (100 MB full-duplex). Data streams in both directions
simultaneously at 100 MB/s.

100h (100 MB half-duplex). Data streams in one direction at a
time at 100 MB/s.

10f (10 MB full-duplex). Data streams in both directions
simultaneously at 10 MB/s.

10h (10 MB half-duplex). Data streams in one direction at a time
at 10 MB/s.
eventlog on|off Turns the console event log on and off. The event log is kept in
eventlog.txt in the root directory of the SmartServer.