Echelon SmartServer 2.2 - Manual (Page 188)

SmartServer 2.2 User’s Guide 189
This table contains the following columns:
Incoming Lists the names of all the source data points in the connections in the
following format: <functional block>/<data point>.
Point of Reference Lists the names of the source or target data points connected to the data
points listed next to them in the Incoming or Outgoing columns in the
following format: <network>/<channel>/<device>/<functional block>/<data
point>. If there is data point next to the point of reference in the Incoming
column, than the point of reference is the target data point in the connection.
Conversely, if there is a data point next to the point of reference in the
Outgoing column, than the point of reference is the source data point in the
connection.
Outgoing Lists the names of all the target data points in the connections in the
following format: <functional block>/<data point>.
Checking Error Messages and Viewing the System Log
When an error or warning occurs on the SmartServer the SmartServer reports them just above the
tree/application frame and records the error or warning in its system log. The error or warning is
signified by an alarm bell and an informative message describing the error or warning. For errors, the
alarm bell and message text are red; for warnings, they are orange. In addition, information messages
that do not indicate any error may appear; these messages are marked with an arrow and black text.
You can open the system log and view all errors and warnings that have occurred since the
SmartServer was last rebooted. To do this, click View and then System Log, or click the alarm bell or
arrow (if visible).