Echelon SmartServer 2.2 - Manual (Page 73)

74 Configuring and Managing the SmartServer
4. Browse to http://<OpenLNS Server Computer IP Address>/EES/AdminService/v4.0/index.htm,
which is the IP address of the i.LON AdminServer tool that is installed on your OpenLNS Server
computer by EES 2.2. For example, if the IP address of your OpenLNS Server computer is
10.2.124.30, enter http://10.2.124.30/EES/AdminService/v4.0/index.htm.
Note: Browse from a computer that is on the same side of the firewall as the SmartServer and the
computer used to access the SmartServer Web pages.

If the i.LON AdminServer tool opens, the SmartServer should be able to communicate with
the LNS Proxy Web Service. Use the Add or Remove Programs Control Panel application to
verify that the version of EES 2.2 matches the SmartServer firmware version. The
SmartServer firmware version is displayed at the bottom right side of the SmartServer Web
pages. You can also view this information by clicking Setup and then clicking System Info
in the SmartServer Web pages, or right-clicking the local SmartServer and clicking System
Info on the shortcut menu.

If the i.LON AdminServer tool does not open, un-install and then re-install EES 2.2. In
addition, verify that there are no port conflicts with any other applications.
Adding an E-mail (SMTP) Server to the LAN
You can add an e-mail (SMTP) server to the LAN to have the SmartServer automatically send e-mail
notifications when a data point is an alarm condition. You must also add Alarm Generator and Alarm
Notifier functional blocks to the SmartServer’s i.LON App (Internal) device and configure them for
the SmartServer to send e-mail notifications. See Chapter 6, Alarming, for more information on
configuring the SmartServer’s alarming applications.
To add an e-mail server to the LAN, follow these steps:
1. Right-click the LAN icon or a dial-out connection icon, point to Add Host, and then click Server
(LNS, Email, Time, IP-852, WebTarget) on the shortcut menu, or if are you adding the time
service to an existing server on the LAN, skip to step 4.
2. The Setup – Host Web page opens, and a server icon is added one level below the LAN icon at
the bottom of the navigation pane or one level below the dial-out connection icon.
3. Enter the IP address or hostname of the e-mail (SMTP) server.