Configuring and managing the smartserver, 3configuring and managing the smartserver – Echelon SmartServer 2.2 User Manual
Page 36
SmartServer
2.2 User’s Guide
37
3
Configuring and Managing the
SmartServer
This chapter describes how to connect your SmartServer to a TCP/IP network. It
describes how to use the Setup Web pages to configure the SmartServer’s properties.
It explains how to add dial-up connections to your SmartServer if an Ethernet
connection is not readily available. It explains how to connect host devices such as
remote SmartServers, OpenLNS Servers, e-mail servers, time servers, IP-852
Configuration Servers, and Web Connection Target servers to your local
SmartServer. It describes how to configure your SmartServer as an IP-852 router and
as a remote network interface (RNI). It describes how to manage your SmartServer,
including how to view its performance; view its system health monitoring
configuration, test its connections; replace it; activate the V40 interface on it; and
migrate an i.LON 100 e3 server network configuration to a SmartServer.