Echelon SmartServer 2.2 - Manual (Page 189)

190 Using the SmartServer Web Interface
By default, the errors (red) are warnings (orange) are listed in descending chronological order, but you
can sort them by clicking a property header. This dialog displays the following properties for each
error or warning message recorded by the SmartServer:
Time A time stamp displaying the date and time when the error or warning was
recorded.
Message Origin The origin of the error or warning, which could be a bus (LON, M-Bus,
Modbus, or custom driver), the SmartServer Web interface, the SmartServer
system, or a SmartServer application.
Message A description of the error or message.
Click Close to return to the SmartServer Web interface. Click Clear to delete all the current messages
listed in the system log.
Note: You can change the type of messages logged by the SmartServer (error, warning, information, or
debugging) in the Global Settings dialog. To open this dialog, click Settings. For more information
on the Global Settings dialog, see the next section, Configuring Global Settings.
Configuring Global Settings
You can use this dialog to set the SmartServer’s SOAP transaction timeout, set the frequency in which
the SmartServer’s built-in Web pages receive data point updates from the SmartServer’s internal data
server, change the organization of the icons in the tree from the current network hierarchy format to the
data point location format used for the i.LON 100 e3 server, enable specific types of icons to always be
shown in the SmartServer tree, enable a synchronization status bar for the network icon in the
navigation pane, and set Modbus address display properties.
To configure the SmartServer’s global settings, follow these steps:
1. Click Settings. The Global Settings dialog opens.