Echelon SmartServer 2.2 - Manual (Page 543)

544 Appendix D - Manually Managing and Deploying SmartServers
6. Copy the following files from the backup to the SmartServer flask disk, if necessary:

web/index.htm (if you modified the SmartServer home page or added a link to your custom
SmartServer Web pages to it; see Chapter 12 for more information).

web/images/[app/ || tree/].gif (if you wrote over any of the SmartServer’s built-in
images, which is not supported).
7. Reboot your SmartServer using the SmartServer Web pages or the SmartServer console
application.

To reboot your SmartServer using the SmartServer Web pages, right-click the local
SmartServer, point to Setup, and then click Reboot on the shortcut menu. The Setup –
Reboot dialog opens. Click Reboot to start the reboot.

To reboot your SmartServer using the SmartServer console application, enter the reboot
command. For more information on using the SmartServer console application, see Appendix
B.
Manually Restoring the SmartServer Firmware
You can manually restore the configuration of a SmartServer from a backup following these steps:
1. Verify that you have the correct user name and password to access your SmartServer via FTP and
that FTP access is enabled on your SmartServer. To do this, follow these steps:
a. Right-click the local SmartServer icon, point to Setup, and then click Security on the shortcut
menu. Alternatively, you can click Setup and then click Security. The Setup – Security
Web page opens.
b. In the General box, verify that the FTP/Telnet User Name and FTP/Telnet Password
properties are correct.
c. In the Service box, verify that the Enable FTP check box is selected.