Echelon SmartServer 2.2 - Manual (Page 513)

514 Appendix B – Using the SmartServer Console Application
Command Description
extract name Extracts the contents of a directory or file created with the compress
command. The directory or file to be extracted must have the
extension .tar.csv.gz, and must be located in the current working
directory. The archive will be extracted into the current directory.
This command is CPU intensive and may cause a delayed response to
requests (for example SOAP requests) that are sent while the
SmartServer is processing the command.
factorydefaults
[keepipaddrs] Resets the SmartServer to its factory default settings. Files added by
the user outside of the //software directory (i.e. Web pages) are not
affected. If you specify the keepipaddrs parameter, the basic IPv4 or
1Pv6 addresses are preserved.
Run this command from the SmartServer bootrom console. See
the Interrupting the Boot Process section later in this appendix for
more information.
ftppassword password Sets the FTP password to password (you cannot use anonymous FTP).
The default password is ilon.
ftpport port Sets the port the used by the SmartServer for FTP communication. The
default port is 21.
ftpuser name Sets the FTP username to name. The default user name is ilon.
format Formats the SmartServer’s flash disk. This command deletes all files,
including the SmartServer’s system image file. After using this
command, you must upload a new software image to the SmartServer.
If you have licensed the IP-852 router, you must also restore the license
file.
Run this command from the SmartServer bootrom console. Be sure
to first back up any files that you may wish to save. See the
Interrupting the Boot Process later in this appendix for more
information.
help Displays a listing of the typically used commands. Help all displays a
complete command list.
history [size] If you do not specify the size parameter, this command displays a
history of console commands issued since the last reboot. You can
specify a size from 10 to 100 to determine how far back the command
history is kept.
hostname name Modifies the hostname. For example, hostname ilon100.
Name characters are limited to letters, digits, and embedded hyphens
(-). The first character must be a letter and the last character must be a
letter or digit.
install idx|name [dmn]sn
nd Installs a L ON W ORKS domain/subnet/icon address for the application
specified by idx. This command is provided for backward
compatibility to add a SmartServer to a pre-installed network.
ipv4address address Modifies the IPv4 network address assigned to the SmartServer. For
example, ipv4address 101.253.100. This command is valid only when
DHCP is turned off.