Echelon SmartServer 2.2 - Manual (Page 331)

332 Alarming
5. Select the Alarm Generator functional block from the Static or Dynamic LonMark folder. The
folder available in the dialog depends on whether the SmartServer is using the static v12 interface
or the dynamic v40interface.

If the SmartServer is using the default static v12 interface, expand the Static entry, select the
Alarm Generator functiona1 block, optionally enter a different name than the default
programmatic functional block name, and then click OK.

If you have activated the dynamic v40 interface on the SmartServer and you are managing the
network in Standalone mode, you can select the Alarm Generator functional block from either
the Static or the Dynamic folder. To select the Alarm Generator functional block from the
Dynamic folder, expand the Dynamic entry, expand the /lonworks/types folder, expand the
bas_controller folder, select the user-defined functional profile template (UFPT) for the
alarm generator, enter a name for the functional block such as “Alarm Generator 1”, and then
click OK.