Echelon SmartServer 2.2 - Manual (Page 291)

292 Using the SmartServer as Network Management Tool
Medium Displays the device’s medium ID as a 1-byte enumeration that identifies
the device functionality. The following is a list of possible medium IDs:
Value Identifier Notes
-1 MED_NUL Invalid
0 MED_OTHER Others
1 MED_OIL Oil
2 MED_ELECTRICITY Electricity
3 MED_GAS Gas
4 MED_RETURN_TEMP Return temperature
5 MED_STEAM Steam
6 MED_HOT_WATER Hot water
7 MED_WATER Water
8 MED_HEAT_METER Heat meter
9 MED_COMPRESSED_AIR Compressed-air
10 MED_RES1 Reserved
11 MED_RES2 Reserved
12 MED_FLOW_TEMP Flow temperature,
outgoing/supply temperature
13 MED_RES3 Reserved
14 MED_SYS_BUS System / Bus
15 MED_UNKNOWN Unknown
Version Specifies the generation or version of the device as 1-byte char. This
value depends on the manufacturer.
5. Click Submit.
6. Create and configure a type translator to integrate the data generated by an M-Bus device into a
L ON W ORKS network. See Integrating M-Bus Devices With a Type Translator in Chapter 11 for
more information on how to do this.
Viewing M-Bus Devices
You can view and configure the all the M-Bus devices in your network or on a specific channel using
the Overview – Devices Web page. This Web page displays the primary or secondary address, parent
channel, and name of each M-Bus device. To view M-Bus devices with the Overview – Devices Web
page, follow these steps:
1. To configure the primary or secondary addresses, or names of the M-Bus devices, click the Driver
option at the top of the navigation pane on the left side of the SmartServer Web interface.
2. Right-click the network or a M-Bus channel in the SmartServer tree, point to Overview, and then
select Devices.