Echelon SmartServer 2.2 - Manual (Page 41)

42 Configuring and Managing the SmartServer
Configuring the SmartServer
After you can connect your local SmartServer to a TCP/IP network, you can use the SmartServer’s
Setup Web pages to configure its TCP/IP, SOAP/HTTP, time, and security properties. When you
change the TCP/IP and security properties of the SmartServer, you may be required to reboot your
SmartServer. The following sections describe how to perform the following configuration tasks for a
SmartServer.

Configure TCP/IP properties.

Configure SOAP/HTTP properties.

Configure time properties.

Configure security properties.

Reboot the SmartServer.
Configuring TCP/IP Properties
If you are connecting your SmartServer directly to a TCP/IP network via the Ethernet port, you must
configure the SmartServer’s TCP/IP connection properties. To configure the TCP/IP properties,
follow these steps:
1. Right-click the SmartServer icon, point to Setup, and then click TCP/IP on the shortcut menu.
Alternatively, you can click Setup and then click TCP/IP to configure the TCP/IP properties on
your local SmartServer.
2. The Setup – Local SmartServer (TCP/IP) Web page opens.