Echelon SmartServer 2.2 - Manual (Page 524)

SmartServer 2.2 User’s Guide 525
3. Add users to specific groups. To do this, click the group under the Groups column to which users
are to be added, click a user, and then click Add User. Repeat this step for each user to be added
to the group.
Note: If you create 16 or more groups of users, you may need to change some of the parameters as
described in the Parameters section later in this appendix.
Locations
Locations are defined as ranges of IP addresses from which a particular group of users can access a
particular folder. “*” is used as a wildcard. To create a location, follow these steps:
The following table lists some example location settings.
Location
Name
IP Address
Range
Comments
All *.*.*.* Any IP address
Tenants 10.1.0.* Any host with IP in the range 10.1.0.1 – 10.1.0.254
Note: 10.1.0.0 is a network address and 10.1.0.255 is
a broadcast address; therefore, they are not included
Topgun 10.1.0.10 IP address of the host used by superuser (property
manager) to update Web pages