Echelon SmartServer 2.2 - Manual (Page 304)

SmartServer 2.2 User’s Guide 305
5. The SmartServer discovers the selected uncommissioned devices if they are already attached to
the network. The Neuron ID property in the Setup - LON Device Driver Web page for each
device is populated as the device is discovered.
Note: If you are using Standalone mode, the device discovery process may take a few minutes.
Manually Acquiring the Neuron ID
To manually acquire the Neuron ID of a L ON W ORKS device, follow these steps:
1. Click Driver.
2. Click the device to be installed in the SmartServer tree or OpenLNS tree. Select one device at a
time because you cannot manually acquire multiple Neuron IDs in a single transaction.
3. The Setup - LON Device Driver Web page opens.
4. Enter the Neuron ID in the Neuron ID box using the service pin, manual entry, or scanning
method.

To use the service pin method, click Use Service Pin in the Neuron ID box and then proceed
to step 5.

To use the manual entry method, enter the 12-digit hex string on the device in the Neuron ID
box and then proceed to step 9.