Echelon SmartServer 2.2 - Manual (Page 292)

SmartServer 2.2 User’s Guide 293
3. The Overview – Devices Web page opens.
4. You can sort the objects listed by clicking a property header.
5. View and /or configure the following properties:
Icon/Status Displays the icon used to represent the M-Bus device in the SmartServer
tree and in the application frame. If the device is offline, this box is
highlighted red.
Address Displays whether the M-Bus device uses primary or secondary addressing.
Primary addressing is preferred because it makes replacing M-Bus devices
more transparent. Each of these addressing methods is described as
follows:

Primary. The primary address is assigned by the network
management tool used to install the M-Bus device (analogous to a
L
ON W ORKS subnet/icon address). Enter a primary address between 0
to 250 for the M-Bus device.

Secondary. The secondary address is manufactured into the device at
the factory (analogous to a L
ON W ORKS Neuron ID). Enter a
secondary address between 0 to 99,999,999 for the M-Bus device.
This property is only displayed in Driver mode; it is not displayed in
General mode.