Displaying bfd mpls detailed information – Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) User Manual
Page 982
952
Multi-Service IronWare Switching Configuration Guide
53-1003036-02
Displaying MPLS BFD information
25
Displaying BFD MPLS detailed information
The following example shows a display of BFD MPLS detailed information as a result of the show
bfd mpls detail command. To view BFD MPLS information for a single LSP or RSVP session, use the
show bfd mpls lsp command.
NOTE
The show bfd mpls lsp command displays the same information as the show bfd mpls rsvp-session
command.
Syntax: show bfd mpls [detail | lsp name | rsvp-session src-addr dest-addr tnnl-id]
This information shown in this display that is not defined in
is described in either
State
The current state of the BFD session:
Up
Down
A.DOWN – The administrative down state
INIT – The Init state
UNKNOWN – The current state is unknown
Interface
The logical port (physical or virtual port) on which the BFD packet is sent out.
The physical port can be either an Ethernet, or VE-enabled interface. The VE
interface ID is specified by the vid variable.
Holddown
The interval in microseconds after which the session will transition to the down
state if no message is received.
Interval
The interval in microseconds at which the local device sends BFD messages to
the remote peer.
RH
Heard from remote.
TABLE 132
Display of BFD MPLS detail information
This field...
Displays...
Interface
The logical port (physical or virtual port) on which the BFD packet is sent out.
The physical port can be either an Ethernet, or VE-enabled interface. The VE
interface ID is specified by the vid variable.
Tx Port:
The physical port on which the BFD packet is sent. When applicable, the Tx
Port field displays a VE interface ID specified by the vid variable.
Rx Port:
The physical port on which the BFD packet is received.
TABLE 131
Display of BFD MPLS information (Continued)
This field...
Displays...
Brocade# show bfd mpls lsp lsp2
Session name State Interface Holddown Interval RH
lsp2 UP eth 1/2 3000000 1000000 Y
Local: Disc: 3, Diag: 0, Demand: 0 Poll: 0
MinTxInterval: 500000, MinRxInterval: 500000, Multiplier: 3
Remote: Disc: 3, Diag: 3, Demand: 1 Poll: 0
MinTxInterval: 1000000, MinRxInterval: 1000000, Multiplier: 3
Stats: RX: 305 TX: 305 SessionUpCount: 1 at SysUpTime: 0:0:4:46.200
Session Uptime: 0:0:3:46.650, LastSessionDownTimestamp: 0:0:0:0.0
Tx Port: eth 1/2, Rx Port: eth 1/2