Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 880)

850 Multi-Service IronWare Switching Configuration Guide
53-1003036-02
Displaying IP information
19
Displaying brief tunnel statistics
Use the show statistics brief tunnel command to display the aggregate statistics for a specific
tunnel or for all tunnels (in page mode). The feature combines both unicast and multicast statistics
into one counter.
To display all of the brief statistics, run the show statistics brief tunnel command.
Syntax: show statistics brief tunnel tunnel-id
To show the brief statistics for a particular tunnel, include the optional tunnel ID. The types of
information in the output are as follows:
TABLE 109 Show IP tunnel display information
This field... Displays...
IPv6 tnnl x UP | DOWN The status of the interface for manual IPv6 tunnel interface x can be one of the
following:
•
UP – The tunnel interface is functioning properly.
•
DOWN – The tunnel interface is not functioning and is down.
GRE tnnl x UP or DOWN The status of the interface for GRE tunnel interface x can be one of the
following:
•
UP – The tunnel interface is functioning properly.
•
DOWN – The tunnel interface is not functioning and is down.
GRE Session Enforce Shows whether the global GRE session enforce feature is enabled. The output
is one of the following:
TRUE – the feature is enabled.
FALSE – the feature is disabled.
IPv6 Session Enforce Shows whether the global IPv6 session enforce feature is enabled. The output
is one of the following:
TRUE – the feature is enabled.
FALSE – the feature is disabled.
IP Tunnel Statistics collection Shows whether the collection of tunnel statistics is enabled. The enable or
disable is a global setting that applies to both directions of GRE and manual
IPv6 tunnels (unicast and multicast).
src_ip The tunnel source can an IPv4 address.
dst_ip The tunnel destination can an IPv4 address.
TTL The TTL value configured for the outer IP header. The range for TTLs is 1 – 255.
TOS The TOS value configured for the outer IP header. The range for TOS values is 1
– 255.
NHT The nextHop Table index value.
MTU The setting of the IPv6 maximum transmission unit (MTU).
Brocade#show statistics brief tunnel
Packets
Tunnel Id Tunnel Type [Rcv-from-tnnl Xmit-to-tnnl]
1 GRE 586046 287497
2 GRE 0 0
3 IPV6-Manual 0 0