Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 404)

374 Multi-Service IronWare Switching Configuration Guide
53-1003036-02
MSTP support for PBB
12
Each variable has the following range.
• Instance ID: 0-4094 (0 for CIST and 1-4094 for MSTI)
• Path Cost: 1-200000000
• Port Priority: 0-240 in the increments of 16
• Instance Priority Value: 0-61440 in the increments of 4096
• VLAN ID: 1-4090
• VPLS ID: 1-4294967294
Executing the above command with a [no] will delete the configured MST instance to VLAN
mapping.
Configuring the Brocade MLX series and Brocade NetIron XMR
The following procedure describes how to configure AS-1, AS-2, and ES-1 in the scenario shown in
Figure 70 .
Configuring AS-1
Tag type configuration
Configure port tag type for S-VLAN to 0x9100.
Brocade_AS-1(config)#tag-type 9100 eth 1/1
Brocade_AS-1(config)#tag-type 9100 eth 1/2
S-VLAN Configuration
Configure VPLS VLANs which will carry the PB traffic, the S-VLAN here is 200.
Brocade_AS-1(config)#router mpls
Brocade_AS-1(config-mpls)#vpls pb-svlan 1
Brocade_AS-1(config-mpls-vpls-pb-svlan)#pbb
Brocade_AS-1(config-mpls-vpls-pb-svlan-pbb)#vlan 200
Brocade_AS-1(config-mpls-vpls-pb-svlan-vlan-200)#tag ethernet 1/1 ethernet 1/2
MSTP Configuration
Brocade_AS-1(config)#mstp-region 2
Brocade_AS-1(config-mstp-region-2)#mstp-region name PB-Domain1
Brocade_AS-1(config-mstp-region-2)#mstp-region rev 1
Brocade_AS-1(config-mstp-region-2)#mstp-region instance 1 vpls 1 vlan 200
Brocade_AS-1(config-mstp-region-2)#mstp-region admin-pt2pt-mac ethernet 1/1 to
1/2
Brocade_AS-1(config-mstp-region-2)#mstp-region start
Configuring AS-2
Tag type configuration
Configure port tag type for S-VLAN to 0x9100.
Brocade_AS-2(config)#tag-type 9100 eth 1/1
Brocade_AS-2(config)#tag-type 9100 eth 1/3
S-VLAN Configuration
Configure VPLS VLANs which will carry the PB traffic, the S-VLAN here is 200