Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 649)

Multi-Service IronWare Switching Configuration Guide 619
53-1003036-02
About Multi-Chassis Trunk (MCT)
18
Brocade(config-cluster-TOR-client-1)#client-interface ether 1/5
Syntax: [no] client-interface interface : ethernet x/y
The ethernet x/y parameter is the ethernet interface.
4. Deploy the cluster client. If cluster is not deployed, the configuration will be taken but the client
FSM will not be started. The consistency checks for client will be done at the time of client
deploy. The following configuration checks will be preformed:
• Client interface is configured
• Client interface is not same as any other client interface or ICL interface
• Client RBridge ID is not same as cluster rbridge or any peer rbridge
Once the client is deployed, the configuration inside the client will not be allowed to change, To
deploy the client configuration, enter a command such as the following.
Brocade(config-cluster-TOR-client-1)deploy
Syntax: [no] deploy
Create cluster client 2
See
Figure 176 and “Create cluster client 1” for additional information on creating cluster clients.
1. Create a cluster client instance and change the mode to the client instance mode.
Brocade(config-cluster-TOR)# client client-2
2. Configure the remote bridge ID cluster on the device so all clients for the device become
members of the cluster.
Brocade(config-cluster-TOR-client-2)#rbridge-id 200
3. Create a cluster client interface.
Brocade(config-cluster-TOR-client-2)#client-interface ether 1/6
4. Deploy the cluster client.
Brocade(config-cluster-TOR-client-2)deploy
Create cluster client 3
See
Figure 176 and “Create cluster client 1” for additional information on creating cluster clients.
1. Create a cluster client instance and change the mode to the client instance mode.
Brocade(config-cluster-TOR)# client client-3
2. Configure the remote bridge ID cluster on the device so all clients for the device become
members of the cluster.
Brocade(config-cluster-TOR-client-3)#rbridge-id 300
3. Create a cluster client interface. The interface can be a single link or LAG port. If it is LAG port,
it should be the primary port of the LAG .
Brocade(config-cluster-TOR-client-2)#client-interface ether 1/7
4. Deploy the cluster client.
Brocade(config-cluster-TOR-client-2)deploy
Configuring Client-1
See
Figure 176 and “Creating LAG-1” for additional information on creating a LAG.