Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 214)

184 Multi-Service IronWare Switching Configuration Guide
53-1003036-02
Configuring super aggregated VLANs
7
Commands for device D
Device D is at the other end of path and separates the channels back into individual VLANs. The
tag type must be the same as tag type configured on the other core device (Device C). In addition,
VLAN aggregation also must be enabled.
Brocade-D(config)# tag-type 9100
Brocade-D(config)# vlan 101
Brocade-D(config-vlan-101)# tagged ethernet 4/1
Brocade-D(config-vlan-101)# untagged ethernet 3/1
Brocade-D(config-vlan-101)# exit
Brocade-D(config)# vlan 102
Brocade-D(config-vlan-102)# tagged ethernet 4/1
Brocade-D(config-vlan-102)# untagged ethernet 3/2
Brocade-D(config-vlan-102)# exit
Brocade-D(config)# write memory
Commands for device E
Since the configuration in Figure 12 is symmetrical, the commands for configuring device E are
identical to the commands for configuring device A.
Brocade-E(config)# vlan 101
Brocade-E(config-vlan-101)# tagged ethernet 2/1
Brocade-E(config-vlan-101)# untagged ethernet 1/1
Brocade-E(config-vlan-101)# exit
Brocade-E(config)# vlan 102
Brocade-E(config-vlan-102)# tagged ethernet 2/1
Brocade-E(config-vlan-102)# untagged ethernet 1/2
Brocade-E(config-vlan-102)# exit
Brocade-E(config)# vlan 103
Brocade-E(config-vlan-103)# tagged ethernet 2/1
Brocade-E(config-vlan-103)# untagged ethernet 1/3
Brocade-E(config-vlan-103)# exit
Brocade-E(config)# vlan 104
Brocade-E(config-vlan-104)# tagged ethernet 2/1
Brocade-E(config-vlan-104)# untagged ethernet 1/4
Brocade-E(config-vlan-104)# exit
Brocade-E(config)# vlan 105
Brocade-E(config-vlan-105)# tagged ethernet 2/1
Brocade-E(config-vlan-105)# untagged ethernet 1/5
Brocade-E(config-vlan-105)# exit
Brocade-E(config)# write memory
Commands for device F
The commands for configuring device F are identical to the commands for configuring device E. In
this example, since the port numbers on each side of the configuration in
Figure 12 are
symmetrical, the configuration of device F is also identical to the configuration of device A and
device B.
Brocade-F(config)# vlan 101
Brocade-F(config-vlan-101)# tagged ethernet 2/1
Brocade-F(config-vlan-101)# untagged ethernet 1/1
Brocade-F(config-vlan-101)# exit
Brocade-F(config)# vlan 102
Brocade-F(config-vlan-102)# tagged ethernet 2/1
Brocade-F(config-vlan-102)# untagged ethernet 1/2
Brocade-F(config-vlan-102)# exit