Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 973)

Multi-Service IronWare Switching Configuration Guide 943
53-1003036-02
show mpls lsp
25
Tunnel interface: The status of the tunnel interface can be one of the following:
•
UP – The tunnel interface is functioning properly.
•
DOWN – The tunnel interface is not functioning and is down.
outbound interface: The outbound interface taken by the active path of the LSP. When the
egress interface is a VE-enabled interface, the VE interface ID specified by
the vid variable is displayed here in the Outbound interface field.
Tunnel index: The tunnel index for the active path of the LSP.
Tunnel instance: The MPLS tunnel interface port ID.
outbound label: The outbound label used by the active path of the LSP.
Path calculated using
constraint-based routing: Whether the explicit path used by the active path was calculated using the
constraint-based routing.
Path calculated using interface
constraint: Directs the router to include the interface address as a constraint when it
determines the shortest path.
Explicit path hop count: The number of explicit hops configured for the LSP, the addresses of the
hops, and whether the hops are strict (S) or loose (L).
Recorded routes: The addresses recorded by the RECORD_ROUTE object during RSVP
signalling.
BFD session status: Describes the status of the BFD session on this LSP as either UP or DOWN.
If a BFD session for the LSP is enabled and the BFD session is DOWN, one
of the following:
reasons for failure will be displayed:
•
BFD disabled globally
•
LSP down
•
Max session exceeded
•
Max LP session exceeded
•
Peer session down
•
Wait for peer
Config param: Describes how the BFD configuration values were derived:
•
global – Displayed if the configuration values were derived from the
router’s global LSP BFD configuration.
•
local – Displayed if the configuration values were derived from a BFD
configuration specific to this LSP.
min-tx: The min-tx value in milliseconds that is configured for this LSP.
min-rx: The min-rx value in milliseconds that is configured for this LSP.
multiplier: The multiplier value that is configured for this LSP.
Negotiated tx-interval: The tx-interval value in milliseconds that has been negotiated between this
router and its peer for this LSP.
rx-interval: The rx-interval value in milliseconds that has been negotiated between this
router and its peer for this LSP.
multiplier: The multiplier value in milliseconds that has been negotiated between this
router and its peer for this LSP.
Local discriminator: Value of the ‘local discriminator’ field in the BFD Control Message as used
by the local router in the last message sent.
remote discriminator: Value of the local discriminator field in the BFD Control Message as
received in the last message sent by the remote peer.
Output field Description