Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 891)

Multi-Service IronWare Switching Configuration Guide 861
53-1003036-02
Multiple VLAN Registration Protocol
20
Topo HW idx : 0 Topo SW idx: 257 Topo next vlan: 0
L2 protocols : NONE
Dynamically Tagged Ports
Statically Tagged Ports : ethe 1/12
Syntax: show vlan
Error messages
Deletion of dynamically learned VLAN
Assume VLAN 10 is dynamically learned over port 1/1. Now when VLAN 10 is manually removed,
the following error message is displayed.
Error - Dynamic VLAN 10 cannot be deleted manually.
Deletion of dynamically created PORT-VLAN membership
Assume VLAN 10 is dynamically learned over port 1/1. Now when port 1/1 is manually removed
from the VLAN, the following error message is displayed.
Error - Dynamically added port 1/1 cannot be deleted from VLAN 10 manually
Adding a VLAN to forbidden list over MVRP enabled port when it is statically configured
For example, assume port 1/1 is statically tagged to VLAN 10. Now when VLAN 10 is added to the
forbidden list on an MVRP enabled port 1/1, the following error is displayed.
Error - Forbidden vlan configuration not allowed as VLAN 10 is statically
configured on port 1/1.
Enabling MVRP when per VLAN instance of STP or RSTP is running
For example, assume per VLAN STP or RSTP is running. While enabling MVRP on the system
following error is displayed.
Error - Please remove all per vlan instances of STP and RSTP.
Enabling MVRP while MSTP is configured
When MVRP is enabled while MSTP is running, the following error message is displayed.
Error - Please remove all MSTP configurations before running MVRP.
Enabling MVRP when metro ring is configured
When MVRP is enabled while metro ring is configured, the following error message is displayed.
Error - Please remove all metro-ring configurations before running MVRP
Enabling MVRP when ERP is configured
When MVRP is enabled while ERP is configured, the following error message is displayed.
Error - Please remove all ERP configurations before running MVRP
Enabling MVRP when VSRP is configured
When MVRP is enabled while VSRP is configured, the following error message is displayed.
Error - Please remove all VSRP configurations before running MVRP
Enabling MVRP when topology group is configured
When MVRP is enabled while a topology group is configured, the following error message is
displayed:
Error - Please remove all topology group configurations before running MVRP