Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 890)

860 Multi-Service IronWare Switching Configuration Guide
53-1003036-02
Multiple VLAN Registration Protocol
20
show mvrp [statistics [ethernet slot/port]]
Brocade# show mvrp statistics ethe 1/1
Port : ethe 1/1
----------------------------------------------------------
Message type Received Transmitted
----------------------------------------------------------
New 0 0
In 0 0
Join In 0 0
Join Empty 0 0
Empty 0 0
Leave 0 0
Leave-all 0 0
----------------------------------------------------------
Total PDUs 0 0
----------------------------------------------------------
Syntax: show mvrp [statistics [ethernet slot/port]]
show mvrp [config]
Brocade# show mvrp config
mvrp enable
mvrp timer join 400 leave 2000 leave-all 10000
!
interface eth 1/5
mvrp enable
mvrp registration-mode forbidden vlan 10
mvrp timer join 400 leave 1500 leave-all 8000
mvrp point-to-point
mvrp applicant-mode non-participant
Syntax: show mvrp [config]
show vlan
The show vlan command is used to list all VLANs and ports (if any) added to it, irrespective of
whether it was added dynamically or statically.
Brocade# show vlan
Total num of entries:3
=======================================================
PORT-VLAN 100, Name [None], Priority Level -, Priority Force 0
Topo HW idx : 0 Topo SW idx: 257 Topo next vlan: 0
L2 protocols : NONE
Dynamically Tagged Ports : ethe 1/1 to 1/3, ethe 1/5
Statically Tagged Ports :
PORT-VLAN 300, Name [None], Priority Level -, Priority Force 0
Topo HW idx : 0 Topo SW idx: 257 Topo next vlan: 0
L2 protocols : NONE
Dynamically Tagged Ports : ethe 1/7 to 1/9, ethe 1/11
Statically Tagged Ports : ethe 1/10
PORT-VLAN 400, Name [None], Priority Level -, Priority Force 0