Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 906)

876 Multi-Service IronWare Switching Configuration Guide
53-1003036-02
CLI Error Messages
21
1. When MMRP is disabled globally.
<14>Sep 13 15:36:48 3-1-A MMRP is disabled globally.
2. When a new MAC is registered.
<14>Sep 13 15:36:48 3-1-A MMRP Mac 011e.8300.2710 registered on port 1/1 vlan 100
3. When an MMRP MAC is removed.
<14>Sep 13 15:36:48 3-1-A MMRP Mac 011e.8300.2710 is removed from port 1/1 vlan
100
CLI Error Messages
The following Error messages are introduced for this feature
1. Timer configuration. The timer configuration in MMRP has the following two restrictions
• Leave timer should be greater than or equal to twice the join timer plus 600ms. If this
condition is not satisfied then the following error message will be displayed.
Error: leave timer value must be greater than twice the join timer plus 600ms
• Leave-all timer should be large relative to leave timer; recommended value is at least
three times the value of leave timer.
Error: leave-all timer value must be greater than three times the leave timer
value
2. If MMRP is disabled globally any MMRP command is issued then the following error will be
displayed.
Error: MMRP is disabled globally, operation rejected.
3. If MMRP is enabled on non-existing vlan then following error will be thrown
Error: Vlan not configured
4. If at the interface level if MMRP is enabled on the vlan is which is not present in the global
configuration then following error message will be displayed.
Example
Brocade#conf t
Brocade#(config)#mmrp enable
Brocade(config)# mmrp include-vlan 10
Brocade(config)#int e 1/1
Brocade(config-if-e1000-1/1)#mmrp include-vlan 300
Error - mmrp vlan 300 must be configured at global level first