Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 694)

664 Multi-Service IronWare Switching Configuration Guide
53-1003036-02
MCT for VRRP or VRRP-E
18
IPv6 VRRP-E short-path forwarding delay
Use IPv6 VRRP-e short-path forwarding delay to configure the time delay required to enable short
path forwarding after reloading the backup router. When configured, short path forwarding will be
enabled only after the configured delay time after the MP initialization is completed (from the time
all modules in the system are UP). Default value is set to 0 seconds.
This is global IPv6 VRRP-E configuration will effect all IPv6 VRRP-E instances.
Brocade(config)# [no] short-path-forwarding-delay 100
Syntax: short-path-forwarding-delay seconds
Sample configurations
Brocade(config)#short-path-forwarding-delay 100
Brocade(config)#ipv6 router vrrp-extended
Brocade(config-ipv6-vrrpe-router)#interface ve 10
Brocade(config-vif-10)# ipv6 address 2003::10:11/64
Brocade(config-vif-10)#ipv6 vrrp-extended vrid 10
Brocade(config-vif-10-ipv6-vrid-10)#backup priority 50
Brocade(config-vif-10-ipv6-vrid-10)#ipv6-address 2003::11:50
Brocade(config-vif-10-ipv6-vrid-10)#short-path-forwarding revert-priority 120
Sample MCT Configuration
Switch A:
vlan 4090
tagged ethe 2/1
router-interface ve 1
!
interface ve 1
ip address 192.168.1.1/24
ICL
CCEP
CEP
CEP
CCEP
LAG
Switch bridge ID:
200
End
stations
End
stations
Bridge ID:
100
Bridge ID:
101
E1
e1/1
e2/1 e2/1
e1/1
E2
Cluster: ABC
E3 E4
CEP
E5
A B
S1