Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) User Manual
Page 596
566
Multi-Service IronWare Switching Configuration Guide
53-1003036-02
Displaying VSRP 2
16
This display shows the following information when you use the vrid num or vlan vlan-id parameter.
For information about the display when you use the aware parameter, refer to
TABLE 69
CLI display of VSRP VRID or VLAN information
This field...
Displays...
Total number of VSRP
routers defined
The total number of VRIDs configured on this device.
VLAN
The VLAN on which VSRP is configured.
auth-type
The authentication type in effect on the ports in the VSRP VLAN.
VRID parameters
VRID
The VRID for which the following information is displayed.
state
This device’s VSRP state for the VRID. The state can be one of the following:
•
initialize – VSRP is not enabled on the VRID. If the state remains
“initialize” after you enable VSRP on the VRID, make sure that the VRID is
also configured on the other routers Routing Switches and that the
routers Routing Switches can communicate with each other.
NOTE: If the state is “initialize” and the mode is incomplete, make sure you
have specified the IP address for the VRID.
•
standby – This device is a Backup for the VRID.
•
master – This device is the Master for the VRID.
Administrative-status
The administrative status of the VRID. The administrative status can be one of
the following:
•
disabled – The VRID is configured on the interface but VSRP or VRRP-E
has not been activated on the interface.
•
enabled – VSRP has been activated on the interface.
Advertise-backup
Whether the device is enabled to send VSRP Hello messages when it is a
Backup. This field can have one of the following values:
•
disabled – The device does not send Hello messages when it is a Backup.
•
enabled – The device does send Hello messages when it is a Backup.
Preempt-mode
Whether the device can be pre-empted by a device with a higher VSRP priority
after this device becomes the Master. This field can have one of the following
values:
•
disabled – The device cannot be pre-empted.
•
enabled – The device can be pre-empted.
NOTE: For the following fields:
•
Configured – indicates the parameter value configured on this device.
•
Current – indicates the parameter value received from the Master.
•
Unit – indicates the formula used tor calculating the VSRP priority and the timer scales in effect for the
VSRP timers. A timer’s true value is the value listed in the Configured or Current field divided by the
scale value.
priority
The device’s preferability for becoming the Master for the VRID. During
negotiation, the Backup with the highest priority becomes the Master.
If two or more Backups are tied with the highest priority, the Backup interface
with the highest IP address becomes the Master for the VRID.
hello-interval
The number of seconds between Hello messages from the Master to the
Backups for a given VRID.