Commands on switch b – Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) User Manual

Page 538

508

Multi-Service IronWare Switching Configuration Guide

53-1003036-02

MRP CLI example

Brocade(config)# vlan 2

Brocade(config-vlan-2)# tag ethernet 1/1 to 1/2

Brocade(config-vlan-2)# metro-ring 1

Brocade(config-vlan-2-mrp-1)# name “Metro A”

Brocade(config-vlan-2-mrp-1)# master

Brocade(config-vlan-2-mrp-1)# ring-interface ethernet 1/1 ethernet 1/2

Brocade(config-vlan-2-mrp-1)# enable

Brocade(config-vlan-2-mrp-1)# exit

Brocade(config-vlan-2)# exit

The following commands configure the customer vlans. The customer vlans must contain both the
ring interfaces as well as the customer interfaces.

Brocade(config)# vlan 30

Brocade(config-vlan-30)# tag ethernet 1/1 to 1/2

Brocade(config-vlan-30)# tag ethernet 2/1

Brocade(config-vlan-30)# exit

Brocade(config)# vlan 40

Brocade(config-vlan-40)# tag ethernet 1/1 to 1/2

Brocade(config-vlan-40)# tag ethernet 4/1

Brocade(config-vlan-40)# exit

The following commands configure topology group 1 on vlan 2. The master vlan is the one that
contains the MRP configuration. The member vlans use the MRP parameters of the master vlan.
The control interfaces (the ones shared by the master vlan and member vlan) also share MRP
state.

Brocade(config)# topology-group 1

Brocade(config-topo-group-1)# master-vlan 2

Brocade(config-topo-group-1)# member-vlan 30

Brocade(config-topo-group-1)# member-vlan 40

Commands on Switch B

The commands for configuring switches B, C, and D are similar to the commands for configuring
Switch A, with two differences: the nodes are not configured to be the ring master. Omitting the
master command is required for non-master nodes.