Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 887)

Multi-Service IronWare Switching Configuration Guide 857
53-1003036-02
Multiple VLAN Registration Protocol
20
MVRP interface level timers
Use the mvrp timer join value leave value leave-all value command to configure the join, leave and
leave-all timers at interface level for MVRP.
Brocade(config-if-e1000-1/1)# mvrp timer join 400 leave 1400 leave-all 10000
Syntax: [no] mvrp timer join value leave value leave-all value
The timer values are set in milliseconds (ms).
The default values for the timers are:
• Join timer - 200ms
• Leave timer - 1000ms (Recommended value: 5000ms)
• Leave-all timer - 10000ms
The Leave timer must be greater than or equal to twice the join timer plus 600ms. The
recommended value for the Leave-all timer is at least three times the value of leave timer.
The acceptable ranges for each time is:
• Join timer - 200 to 2147483600 ms
• Leave timer - 1000 to 2147483600 ms
• Leave-all timer - 10000 to 2147483600 ms
MVRP interface level registration-mode configuration
Configuring the registration mode of an interface for MVRP.
Brocade(config-eth-1/1)#mvrp registration-mode forbidden vlan 10
Syntax: [no] mvrp registration-mode forbidden [vlan-id | vlan-id to vlan-id]
By default, registration mode is normal. For a static VLAN configuration, registration mode is
automatically set to Fixed.
The mvrp registration-mode forbidden command will accept values from 1 to 4090.
MVRP configuration examples
Single interface MVRP configuration example
Brocade(config)#int e 1/1
Brocade(config-eth-1/1)#mvrp enable
Brocade(config-eth-1/1)#mvrp registration-mode forbidden vlan 10
Brocade(config-eth-1/1)#mvrp timer join 400 leave 1400 leave-all 10000
Multiple Interface (consecutive) MVRP configuration example
Brocade(config)#int e 1/1 to e 1/2
Brocade(config-mif-1/1-1/2)#mvrp enable
Brocade(config- mif-1/1-1/2)#mvrp registration-mode forbidden vlan 10
Brocade(config- mif-1/1-1/2)#mvrp timer join 400 leave 1400 leave-all 10000
Multiple Interface (non-consecutive) MVRP Configuration
Brocade(config)#int e 1/1 e 1/3 e 1/5
Brocade(config-mif-1/1,1/3,1/5)#mvrp enable
Brocade(config-mif-1/1,1/3,1/5)#mvrp registration-mode forbidden vlan 10
Brocade(config-mif-1/1,1/3,1/5)#mvrp timer join 400 leave 1400 leave-all 10000