Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 169)

Multi-Service IronWare Switching Configuration Guide 139
53-1003036-02
Deploying a LAG
5
Sample Output Cont….
Alignment 0 FCS 0
GiantPkts 0 ShortPkts 0
InBitsPerSec 782177316 OutBitsPerSec 466226351
InPktsPerSec 90896 OutPktsPerSec 99992
InUtilization 7.96% OutUtilization 4.82%
Syntax: show interface lag lag-name
The lag-name or lag ID parameter can be used to display the detailed information of a specified the
LAG. If no LAG name or LAG ID is specified, the detailed information of all the LAGs configured in
the system will be displayed.
Displaying the running configuration for a LAG
The show running-config lag command displays the running configuration for a specified LAG or all
LAGs as specified in the parameters.
Brocade# show running-config lag detailed
!
lag "lag1" static id 1
ports ethernet 1/1
ports ethernet 1/2
ports ethernet 1/3
primary-port 1/1
deploy
!
lag "lag2" static id 2
ports ethernet 1/4
primary-port 1/4
Syntax: show running-config lag lag name
The lag name option displays the running configuration for the specified LAG. The lag id option may
also be used to display the same information.
Use the detailed option to display the running-config on a specific lag name or lag id. If no LAG
name or LAG id is specified, the information of the entire LAG configured in the system will be
displayed.
Available variations of the command include:
Syntax: show running-config lag
Syntax: show running-config lag detailed
Syntax: show running-config lag detailed lag id
Syntax: show running-config lag detailed lag name
Syntax: show running-config lag lag id
Syntax: show running-config lag lag name