Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 336)

306 Multi-Service IronWare Switching Configuration Guide
53-1003036-02
802.1ag over PBB OAM
11
Sample configuration output
Syntax: show cfm domain domainName ma maName mep-id mepId
Brocade # show cfm domain D2 ma 1 mep-id 5000
Domain: customer
Index: 1
Level: 7
Maintenance association: admin
Ma Index: 2
CCM interval: 10000 ms
ESI aaa VLAN ID: 100
Priority: 7
MEP Direction MAC PORT PORT-STATUS-TLV
==== ========= ========= ======= ================
1 DOWN 0024.3863.7741 ethe 1/1 Y
Y – Means port status tlv is enabled for the MEP
N – Means port status tlv is not enabled for the MEP
Brocade #show cfm connectivity do bvlan ma bvlan rmep-id 5000
Domain: bvlan Level: 5
Maintenance association: bvlan VLAN VLAN/VPLS/VLL ID: 250 Priority: 5
CCM interval: 1000 ms
RMEP MAC PORT Oper Age CCM RDI Port Intf Intvl Seq core
State Val Cnt Status Status Error Error Fault level
==== ============== ==== ===== ==== ====== ======= ==== ====== ====== === ==
5000 0024.3898.da20 3/1 OK 2156 216030 N 2 0 N N N
Value Port Status
1 Port Blocked ( Not Forwarding)
2 Port Forwarding
802.1ag RDI
The Remote Defect Indication (RDI), a single bit, is carried in CCM packets. The absence of RDI in a
CCM indicates that the transmitting MEP is receiving CCMs from all RMEPs. The presence of RDI
indicates that transmitting MEP is not receiving CCM from one or more RMEPs.
Brocade#show cfm connectivity domain customer ma admin rmep-id 1
Output:
Domain: customer Level: 7
Maintenance association: admin VLAN VLAN/VPLS/VLL ID: 100 Priority: 7
CCM interval: 100ms
PORT Oper Age
RMEP MAC State Val Cnt CCM RDI
==== ========= ====== ===== ===== ======= ==========
1 0024.3863.7745 1/1 OK 8180 13 Y
Port Intf Intvl Seq
Status Status Error Error
====== ====== ===== =====
0 0 N N