Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 229)

Multi-Service IronWare Switching Configuration Guide 199
53-1003036-02
Clearing extended VLAN counters
7
To display VLAN counters information for switched packets on a specific port on a VLAN, enter the
following command.
Brocade# show vlan 10 statistics ethernet 14/1 switched
VLAN 10: Extended Switched Counters (only applicable for G2 modules):
Interface RxPkts TxPkts RxBytes TxBytes
eth 14/1 0 0 0 0
To display detailed VLAN counters information on a specific port on a VLAN, enter the following
command.
Brocade# show vlan 10 statistics ethernet 14/1 detail
VLAN 10: Extended Counters (only applicable for G2 modules):
Interface RxPkts TxPkts RxBytes TxBytes
eth 14/1
Routed 0 0 0 0
Switched 0 0 0 0
Combined 0 0 0 0
Syntax: show vlan vlan id statistics ethernet port-id [detail |routed |switched]
The vlan-id parameter specifics the VLAN ID of the port.
The slot/port parameter specifies the interface module location of a 8x10g module.
Use the routed option to view the counters of routed packets.This option is only accepted if the
accounting mode is to count routed and switched packets separately.
Use the switched option to view the counters of switched packets. This option is only accepted if
the accounting mode is to count routed and switched packets separately.
Use the detail option to view the counters of routed packets, counters of switched packets, and
counters of both routed and switched packets. This option is only accepted if the accounting mode
is to count routed and switched packets separately.
If the “routed” or “switched” option is specified, counters for only routed and switched packets are
displayed respectively, otherwise the output displays combined statistics for both routed and
switched packets.
TABLE 32 Output description for the show vlan command
Clearing extended VLAN counters
You can use the following commands to clear the extended VLAN counters.
Field Description
Interface The interface the counter statistics are displayed.
RxPkts The number of packets received at the specified port.
TxPkts The number of packets transmitted from the specified port.
RxBytes The number of bytes received at the specified port.
TxBytes The number of bytes transmitted from the specified port.