Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 881)

Multi-Service IronWare Switching Configuration Guide 851
53-1003036-02
Displaying IP information
19
Displaying tunnel statistics
Use the show statistics tunnel command to display the aggregate statistics (including unicast and
multicast statistics) for a port-range for each packet processor (PPCR) for every LP module in the
system. If you enter the command with no tunnel ID, the output displays statistics for all tunnels in
page-mode. This command displays only the port ranges that have either unicast or multicast
traffic and displays nothing if the LP does not have any non-zero counters. For this example, the
LP2 is a four-port 10G card.
Syntax: show statistics tunnel tunnel-ID
The optional tunnel-ID parameter lets you specify a particular tunnel, otherwise all tunnel statistics
are shown. The command output contains the following types of information.
Displaying interface statistics for a tunnel
TABLE 110 Show IP tunnel display information
This field... Displays...
Tunnel ID For each tunnel displayed, the Tunnel ID indicates the tunnel for which
the statistics are displayed.
Tunnel Type The tunnel type is either GRE or manual IPv6.
Packets Rcv-from-tnnl The number of packets that have arrived from the tunnel.
Packets Xmit-to-tnnl The number of packets that have been sent to the tunnel.
TABLE 111 Show IP tunnel display information
This field... Displays...
Tunnel ID For each tunnel displayed, the Tunnel ID indicates the tunnel for which the
statistics are displayed.
Tunnel Type The tunnel type is either GRE or manual IPv6.
In-ports The Ethernet ports traversed by the tunnel.
Packets Rcv-from-tnnl The number of packets that have arrived from the tunnel.
Packets Xmit-to-tnnl The number of packets that have been sent to the tunnel.
Brocade#show statistics tunnel 1
Packets
Tunnel Id Tunnel Type In-Port(s) [Rcv-from-tnnl Xmit-to-tnnl]
1 GRE e2/1 - e2/2 586046 287497
e2/3 - e2/4 100340 150034