Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 974)

944 Multi-Service IronWare Switching Configuration Guide
53-1003036-02
show mpls lsp
25
Example
Brocade# show mpls lsp lsp3
LSP lsp3, to 10.22.22.2
From: 10.11.11.1, admin: UP, status: UP, tunnel interface(primary path):
tnl2
Times primary LSP goes up since enabled: 1
Metric: 0, number of installed aliases: 0
Maximum retries: 0, no. of retries: 0
Pri. path: NONE, up: yes, active: yes
Setup priority: 7, hold priority: 0
Max rate: 0 kbps, mean rate: 0 kbps, max burst: 0 bytes
Constraint-based routing enabled: yes
Tie breaking: random, hop limit: 0
Active Path attributes:
Tunnel interface: tnl2, outbound interface: e1/2
Tunnel index: 1, Tunnel instance: 1 outbound label: 3
Path calculated using constraint-based routing: yes
Path calculated using interface constraint: no
Explicit path hop count: 1
8.10.1.2 (S)
Recorded routes:
Protection codes: P: Local N: Node B: Bandwidth I: InUse
8.10.1.2
BFD session status: UP
Config param: global, min-tx: 1000, min-rx: 1000, multiplier: 3
Negotiated tx-interval: 1000, rx-interval: 3000, multiplier: 3
Local discriminator: 1, remote discriminator: 1
Fast Reroute: one-to-one backup desired
Detour LSP: UP, out-label: 3, outbound interface: e1/1
History
Related
commands
None.
Fast Reroute: The method of Fast Reroute configured for this LSP. Currently only
one-to-one backup is available.
Detour LSP: Indicates if the detour route is UP or DOWN.
out-label: The outbound label used when sending traffic over a detour LSP.
outbound interface: The physical interface on the router that is used for the detour route.
Output field Description
Release Command history
Multi-Service NetIron Release 05.6.00 The existing command output is extended to show BFD information when
the BFD administrative state is enabled.