Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 616)

586 Multi-Service IronWare Switching Configuration Guide
53-1003036-02
Displaying topology group information
17
This command adds the master VLAN in ESI identified by the VLAN ID to the topology group. The
VLAN must already be configured in the ESI “esi-name”. Make sure all the Layer 2 protocol settings
in the VLAN are correct for your configuration before you add the VLAN to the topology group. A
topology group can have only one master VLAN.
Syntax: [no] member-vlan esi-name vlan-id
This command adds a member VLAN in ESI identified by the VLAN ID to the topology group. The
VLAN must already be configured in the ESI “esi-name”.
Syntax: [no] member-group esi-name num
This command adds a VLAN group in ESI identified by “esi-name” to the topology group. The num
specifies a VLAN group ID. The VLAN group must already be configured.
Displaying topology group information
This section contains examples of the show topology-group output. Support for topology groups
within an ESI is supported on a minority of platforms (listed in
Table 75 ), so its example appears at
the end of this section.
Displaying topology group information on a Brocade NetIron XMR or
Brocade MLX series device
The show topology-group command offers a choice between one of two mandatory parameters.
The command syntax (on a Brocade NetIron XMR or Brocade MLX series device) is as follows.
Syntax: show topology-group group-id | hw-index-table [hw-index]
The first example in this section utilizes the first possible mandatory parameter, group-id. The
second example utilizes the second possible mandatory parameter, hw-index-table, along with an
optional variable, a hardware index number.
Display topology group information by using a Group ID
To display topology group information for group 10, enter the show topology-group command.
Syntax: show topology-group group-id
Brocade#show topology-group 10
Topology Group 10
==================
Topo HW Index : 0
Master VLAN : 10
VPLS VLAN exist : TRUE
Member VLAN : 20
Member Group : None
Member VPLSs : vpls id 200 vlan 200 200 to 250
vpls name vpls100 vlan 300 inner-vlan 5
vpls id 5 vlan 300
vpls id 5 vlan 300 inner-vlan 5
vpls id 5 vlan 300 inner-vlan 20 to
Control Ports : ethe 3/11 to 3/12 ethe 3/15 to 3/16
Free Ports :