Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 635)

Multi-Service IronWare Switching Configuration Guide 605
53-1003036-02
About Multi-Chassis Trunk (MCT)
18
Single level MCT example
FIGURE 176 Single level MCT
The following steps are task for configuring a MCT scenario as shown in Figure 176 .
NOTE
Save the current configuration files for both chassis operating in standalone mode before you begin
creating a MCT.
TOR-A (Top of rack MCT capable switch)
See
Figure 176 .
Creating LAG-1
1. You can either assign a LAG ID explicitly or it will be automatically generated by the system. The
LAG ID stays the same across system reload and hitless upgrade.
The command to configure LAGs allows explicit configuration of the LAG ID for static and
dynamic LAGs.
To create a LAG with the LAG ID option, enter a command such as the following.
Brocade(config)# lag 1 dynamic
Brocade(config-lag-1)#
Syntax: [no] lag [static | dynamic] [id ]