Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 90)

60 Multi-Service IronWare Switching Configuration Guide
53-1003036-02
Flash memory and Auxiliary Flash card file management commands
3
However, in three previous sessions, switchovers occurred. In sessions #1 and #3, the switchovers
occurred because the software was upgraded to “Ver3.7.0T163”. In session #2 the switchover
occurred because the active module was rebooted. In sessions #1 and #3, the modules installed in
M1 were the active modules, while the modules installed in M2 were the standby modules. In
session #2, the module installed in M2 was the active module, while the module installed in M1
was the standby module.
To view the system log or traps logged on an SNMP trap receiver, enter the following command at
any level.
This output indicates that one switchover occurred.
Flash memory and Auxiliary Flash card file
management commands
The Brocade system supports file systems in the following locations:
• Flash memory on the management module
• An Auxiliary flash card inserted in management module slots 1 or 2
Table 16 outlines the root directory for each file system.
This section describes commands that manage the files in flash memory and on the flash cards.
Use the file management commands to perform the following tasks:
Brocade# show log
Syslog logging: enabled (0 messages dropped, 0 flushes, 0 overruns)
Buffer logging: level ACDMEINW, 24 messages logged
level code: A=alert C=critical D=debugging M=emergency E=error
I=informational N=notification W=warning
Static Log Buffer:
Sep 28 11:31:25:A:Power Supply 1, 1st left, not installed
Sep 28 11:31:25:A:Power Supply 3, middle left, not installed
Sep 28 11:31:25:A:Power Supply 4, middle right, failed
Sep 28 11:31:25:A:Power Supply 5, 2nd right, not installed
Dynamic Log Buffer (50 lines):
Sep 27 18:06:58:I:Interface ethernet6/2, state up
Sep 27 18:06:57:I:Interface ethernet3/2, state up
Sep 27 15:39:42:I:Interface ethernet3/2, state up
Sep 27 15:39:42:I:Interface ethernet6/2, state up
...
Sep 27 14:23:45:N:Module up in slot 6
Sep 27 14:23:45:N:Module up in slot 3
Sep 27 14:23:27:A:Management module at slot 9 state changed from standby to
active
TABLE 16 Brocade file system root directories
File system Root directory
Flash memory /flash/
Auxiliary flash card in slot 1 /slot1/
Auxiliary flash card in slot 2 /slot2/